Installation is a simple process. 

The MemoMaid is attached to the front edge of the monitor using a double-sided foam tape.

Step 1. 
Ensure the monitor is clean and free of dust and residue. Clean the front edge of the monitor, with a soft damp cloth using warm water or a mild cleaner. Be careful not to damage monitor screen. Make sure edge of monitor is completely dry before installing.

Step 2. 
Determine what side of the monitor the holder will go. This will be determined by the amount of room available, or for proper ergonomic positioning, by whichever eye is the dominant eye. (See Ergonomics section for further instruction on how to determine which eye is your dominant eye.)

Step 3. 
Once you have determined which side the holder will mount on, remove the covering off the strip of foam tape on the back of the holder. Line up the holder to the inside edge of the monitor frame. When in the proper place, press the holder to the front edge of the screen, running your fingers along the edge to ensure full contact.

Removal of The MemoMaid.

Removal of the MemoMaid is easy and non destructive to the monitor.
Slowly and carefully pull the MemoMaid's outside edge towards you tearing away the MemoMaid. The foam tape will tear leaving a strip of tape stuck to the monitor. Using your thumb, roll the stuck tape
upwards until residue is removed. Wash edge of monitor with a damp cloth.